Starting with: to put on new traction tires on your loco keep in mind that the Original LGB traction tires are no rubber bands. They can not really be stretched. Klaus says a screwdriver is a good tool to help the traction tire onto the wheel. Start by putting the traction tire on a part of the wheel, lead it around as far as you can go, then, holding it in place with one hand, use the screwdriver to help lift the traction tire completely onto the wheel. If the traction tire gets strechted too much, and a little more than 1/8" would be too much, it will break/split.
About power shoes: If they are too run down and used up on your loco they can actually hurt the value of your loco and wears out your tracks.
Most importantly: If you need to "glue something back on" to your LGB loco, puhhleeeze email Klaus first to make sure you're using the correct glue and not something from your grandkid's school supply kit. That (Gilmer's) glue can do a lot of harm to the LGB plastic. And never EVER use hot glue!
On other news: our lawyer advised us to put to your attention, dear reader, again this matter: the email contact
On a lighter note: The Toy Fair in Nuremberg, Germany will open its gates on February 1, 2012. We will have our very own "Our Man in Havanna..., ahh Nuremberg", at the Fair to report directly from the Fair; and will have the hottest topics right here on this blog.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.